Stone as a material that lay the ground is widely used, noble, elegant, light can jian people adornment effect which is very popular. The maintenance of the system in the stone continuous improvement of wax, faces treatment process, we can ensure that the stone light. But the stone material is not the adjacent joint but there has been no good treatment for stone, the stone material juncture the shop is stuck or stone material itself is not enough and the existence of the smoothness of mouth, stone cut juncture after a period of using, juncture can appear not reversible pollution, on the one hand, can cause joints were black, on the other hand besmirch penetration to stone by stone lesions in pore, serious damage of material of stone of integral aesthetic feeling.
Stone seamless processing so-called grinded no juncture that is already laid in a good tablet gaps in adjacent to color and SLATE approximate special filled seam an agent to fill in the gap, and then after processing machinery and professional technology to grinding, polishing processing. In this way, after the show with SLATE of, whole is not divided the stone material of aesthetic feeling.
Construction Stone seamless processing construction technology generally have the following steps:
1, first the stone gap between the original filler clean up, and then use the special sewing machine to open the stone material of the original stone installation ZhongFeng neatly to cut a split, which makes the width of the gap between the stone material sent to lowest, then use the marble of color close to stone glue the fill. (note: if've done ZhongFeng processing is the new open without seam).
2, use close to stone material itself the marble of color and marble glue to glue the perfect toning, make full close to the color of the original stone material to improve the whole feeling, to achieve optimal visual effect.
3, will adjust the good marble glue, glue due to filling out the marble is set after a certain degree of contraction, so should make a little higher than stone material plane marble glue, so not DuoCi filling.
4, the burnish PaoGuangPian and grind the filling agent, to that of the stone into a horizontal plane, increase stone material, and resolve the gap between the wholeness of the high and low a problem, prevent aperture to black again. Use granite refurbished machine with special cut of mouth to mouth grinding cut a proceeding carefully burnish, make its and stone into a plane of the whole.
5, polishing: use the special granite polishing machine, from 50-3000 stone material of joint from coarse to fine ground of stone material, cause the ground level such as new light.
6, crystal processing: the crystal powder and crystallization stone with grinding machine polishing agent either, in polishing under pressure and crystalline powder for stone in high temperature effect happened under physical and chemical synthesis reactions, form a layer of dense, hard crystallization protection layer. After the crystallization can increase color and brightness, also can achieve prevent slippery, waterproof, prevent oil, such as effectiveness.
After the above process after processing, have very good gap will brightness, and stone, whole feels very, very close to the color is very strong, and, because of the marble to bear or endure corrupt, glue water resistance, oxidation resistance, won't produce black seam.
没有评论:
发表评论