Marble Fireplace Mantels Installation Instructions

Materials for marble fireplace mantels installation
- Measuring tape
- pencil
- 2 or 4-ft. level
- putty knife
- 2 angle brackets
- 1" screws
- Marble glue

Each Marble Fireplace Mantel Consists of 5 main pieces:
hearth (1)
two side rails (3)
central panel (5)
and mantel shelve (6)
as shown in the installation diagram

Marble Mantels Installation
To install Marble Fireplace Mantel, please, follow these simple instructions:
Step 1
Determine the wall location of fireplace mantel and mark the center point. Measure the length of the hearth (1) and divide this measurement by two. Starting at the center point measure out 1/2 the hearth length and mark. This will be the edge mark for the hearth.
Step 2
Place the hearth (2), on the flat level surface before the firebox starting at the mark
Step 3
Individually place each side rail (3), in the slot (2) found on the hearth then...
Step 4
Secure each side rail (3) to the back wall using a small angle bracket (4) and screws (please refer to the detail drawing). Use the level to ensure that each side rail is perpendicular, adjust as necessary.
Step 5
Place the central panel (5), on the outer ledge of the side rails
Step 6
Center the mantel shelve (6), on the top of the side rails (3) and central panel (5)
Remember to glue each part using the marble glue
Start relaxing in the luxury of your Inviting Home